U++ framework: Newbie corner » HowTo bind StaticImage to SQL

Home » Community » Newbie corner » HowTo bind StaticImage to SQL

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Re: HowTo bind StaticImage to SQL [message #43616 is a reply to message #43615]

Sun, 14 September 2014 05:16

jerson
Messages: 202
Registered: June 2010
Location: Bombay, India

Experienced Member

Hello Didier

Thanks for your help. I am trying to figure out a way to feed the filename from a SQL.Field to the staticimage control. The Database holds just the file name. All other parameters are correctly tied to their respective controls. The only one that does not work is StaticImage.Set(String _filename). I suppose it is doing that since it is not an editable class.

If that is not possible, would you know how to get the field value from the cursor position on the sqlarray control? I could then use the whenevent to update the static control. Is that possible at all?

regards

Report message to a moderator

[Message index]

		HowTo bind StaticImage to SQL By: jerson on Sat, 13 September 2014 06:32
		Re: HowTo bind StaticImage to SQL By: Didier on Sat, 13 September 2014 22:26
		Re: HowTo bind StaticImage to SQL By: jerson on Sun, 14 September 2014 05:16
		Re: HowTo bind StaticImage to SQL By: jerson on Mon, 15 September 2014 07:58
		Re: HowTo bind StaticImage to SQL By: koldo on Tue, 16 September 2014 09:46
		Re: HowTo bind StaticImage to SQL By: jerson on Tue, 16 September 2014 10:25
		Re: HowTo bind StaticImage to SQL By: koldo on Wed, 17 September 2014 08:09
		Re: HowTo bind StaticImage to SQL By: jerson on Wed, 17 September 2014 12:32
		Re: HowTo bind StaticImage to SQL By: koldo on Thu, 18 September 2014 08:40

Previous Topic:	StaticImage cannot show BMP file
Next Topic:	>Port 9(say port 10)

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat May 30 08:11:23 GMT+2 2026

Total time taken to generate the page: 0.00538 seconds