U++ framework: Newbie corner » Can't Ultimate++ use Japanese?

Home » Community » Newbie corner » Can't Ultimate++ use Japanese?

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Re: Can't Ultimate++ use Japanese? [message #46106 is a reply to message #46092]

Tue, 08 March 2016 10:59

kurete
Messages: 17
Registered: March 2016
Location: Japan

Promising Member

I change the encode to UTF-8 BOM from UTF-8 in TheIDE.

Then Build became possible. However, the character isn't indicated.

Also, TheIDE stop movement when I input Japanese in this state.

TheIDE normally works when inputting Japanese using a copy and paste.

I'm using MSC15 for a Build method

What is this?

Report message to a moderator

[Message index]

		Can't Ultimate++ use Japanese? By: kurete on Thu, 03 March 2016 21:01
		Re: Can't Ultimate++ use Japanese? By: koldo on Fri, 04 March 2016 09:11
		Re: Can't Ultimate++ use Japanese? By: mr_ped on Sat, 05 March 2016 00:55
		Re: Can't Ultimate++ use Japanese? By: kurete on Tue, 08 March 2016 10:59
		Re: Can't Ultimate++ use Japanese? By: deep on Mon, 14 March 2016 13:03
		Re: Can't Ultimate++ use Japanese? By: deep on Mon, 14 March 2016 13:12
		Re: Can't Ultimate++ use Japanese? By: kurete on Tue, 15 March 2016 23:39
		Re: Can't Ultimate++ use Japanese? By: mr_ped on Wed, 16 March 2016 10:58

Previous Topic:	"\n" does not work on DrawText
Next Topic:	Ridiculous behavior of the hotkeys Ctrl+Alt+right and Ctrl+Alt+left in the Stacking mode

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Jul 04 11:06:16 GMT+2 2026

Total time taken to generate the page: 0.01118 seconds