U++ framework
Do not panic. Ask here before giving up.
Home » Community » Newbie corner » Selecting MYAPPS after starting theide.exe it is blank (Open myapps in theide ??? )
Re: Selecting MYAPPS after starting theide.exe it is blank [message #46210 is a reply to message #46208] Sat, 26 March 2016 12:02 Go to previous messageGo to previous message
Klugier is currently offline  Klugier
Messages: 1119
Registered: September 2012
Location: Poland, Kraków
Senior Contributor
Hello,

I think the problem is how you specific uppsrc dir in MyApps assembly. Can you post screenshot with your assembly setup. Alternativly you can copy path to uppsrc from other assemblise like reference or examples. Make sure you have following paths in your assembly: $(MyAppDir);$(UppsrcDir). Moreover, make sure you have semicolon between this two paths.

Sincerely,
Klugier

U++ - one framework to rule them all.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Big problem updating upp from version 6163 to 9614
Next Topic: Switch control on the main window
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Sep 18 14:40:10 GMT+2 2026

Total time taken to generate the page: 0.00772 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.2.0.
Copyright ©2001-2025 FUDforum Bulletin Board Software