U++ framework: U++ MT-multithreading and servers » Simulation in its own thread.

Home » U++ Library support » U++ MT-multithreading and servers » Simulation in its own thread.

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Re: Simulation in its own thread. [message #8089 is a reply to message #8017]

Tue, 06 February 2007 20:45

yeus
Messages: 19
Registered: October 2006

Promising Member

would it be possible to derive the Simulation (If I have an interface-class to the simulation) from a thread and a critical section and locking itself, while doing any action? An object trying to get acces to the simulation would then need to wait until the simulation has through its current loop... After this the object ges access to the simulation, and after done with reading, simulation starts all over....

sorry dont have upp here right now. that's why i'm asking whether this is possible nd not just trying it out Smile

greetings, Tom

Report message to a moderator

[Message index]

		Simulation in its own thread. By: yeus on Sun, 04 February 2007 13:31
		Re: Simulation in its own thread. By: fallingdutch on Sun, 04 February 2007 14:01
		Re: Simulation in its own thread. By: yeus on Tue, 06 February 2007 20:45

Previous Topic:	SSLSocket VerifyPeer -> how to set trusted CAs?
Next Topic:	MT & File Access

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Oct 15 23:04:08 GMT+2 2026

Total time taken to generate the page: 0.00587 seconds