Home » Community » Newbie corner » Minimum required to debug
Minimum required to debug [message #43641] |
Wed, 17 September 2014 13:31 |
jerson
Messages: 202 Registered: June 2010 Location: Bombay, India
|
Experienced Member |
|
|
Hello
Can someone please tell me what are the minimum requirements to get the IDE to debug programs?
My current config is WinXP+TheIDE(7635)+MinGW32(gdb7.6.1)
Build with FULL DEBUG option as default.
I did all I could to try make this work, but, it just does not work.
Using gdb MI2 mode, legacy does not work. In MI2 mode, I see a Running.... message which disappears when a breakpoint is seemingly hit. Registers which show blank values now get *******. Rest everything is blank. No disassembly / line highlight happens. Press F10, Running.... then blank. So, apparently, debugger seems to work, but screen is not getting refreshed.
It is obvious I am missing something on my machine. I do not have Visual Studio. Is that a problem for debugging?
Comments appreciated.
Regards
Jerson
|
|
|
Goto Forum:
Current Time: Mon May 13 12:30:33 CEST 2024
Total time taken to generate the page: 0.02389 seconds
|