U++ framework
Do not panic. Ask here before giving up.
Home » U++ TheIDE » U++ TheIDE: Compiling, Linking, Debugging of your packages » Using BLITZ in release mode
Re: Using BLITZ in release mode [message #29354 is a reply to message #29352] Fri, 15 October 2010 22:38 Go to previous messageGo to previous message
Novo is currently offline  Novo
Messages: 1433
Registered: December 2006
Ultimate Contributor
dolik.rce wrote on Fri, 15 October 2010 15:40


For me it works correctly. I think the problem might be somewhere else... Are you sure that the modification times of the files are older than one hour?



I figured out what's the problem. Besides Build Mode BLITZ should also be enabled in Output Mode. Unfortunately, this will create a separate GCC.Blitz.Gui.Shared configuration, which is not created in case of Debug Mode. Sad

Otherwise it works pretty well. Smile

Overhead in case of TheIDE is ~12k and ~40k in case of a small console application. This is acceptable.

Regards,
Novo

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Can't build SMTP example under VS2012
Next Topic: Help: custom build
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sat Oct 17 13:21:54 GMT+2 2026

Total time taken to generate the page: 0.00599 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.2.0.
Copyright ©2001-2025 FUDforum Bulletin Board Software