Home » Extra libraries, Code snippets, applications etc. » Applications created with U++ » Agilent Lab Equipment Automation
| Agilent Lab Equipment Automation [message #36848] |
Wed, 11 July 2012 22:28  |
cma21
Messages: 1
Registered: July 2012
Location: Washington D.C.
|
Junior Member |
|
|
Hey All,
I am trying to automate my Agilent lab equipment to make testing procedures more efficient. I connect to my instruments via LAN and use a SCPI command controller to develop most of my commands in C++.
My objective is to:
1. Open a saved waveform state from my signal generator (from a list)
2. Have my analyzer use an "Auto Tune" softkey or automatically adjust to view the Frequency and dBm Power automatically as the file is opened in the previous step
3. If step 2 is not possible, I would desire to manually enter the values of Frequency and Power and adjust the screen of the Analyzer.
4. From here I would like to save the image present on the analyzer screen to a directory.
I am very new to Ultimate++ so I do not have a ton of experience using the interface. So with that any information on how to start such a task or develop a basic implementation towards completing this would be greatly appreciated!
Thanks in advance!
|
|
|
|
|
|
Goto Forum:
Current Time: Fri Apr 25 12:40:02 CEST 2025
Total time taken to generate the page: 0.00575 seconds
|
Members
Pages
Help
Register
Login
Home
), welcome to the Forum.
