U++ framework: Newbie corner » Problem using a switch control

Home » Community » Newbie corner » Problem using a switch control

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Re: Problem using a switch control [message #45608 is a reply to message #45605]

Tue, 15 December 2015 12:46

mirek
Messages: 14290
Registered: November 2005

Ultimate Member

I see.

Well, the 'key' is the second argument to Set and right now should be unique (that said, while this is the first case when this causes the problem, maybe it is not necessary requirement and it would be possible to support your use-case directly).

Anyway, right now, fix is easy - use i as second argument too... (you will have to store sql[DRUM] in some array, but that is easy).

Mirek

Report message to a moderator

[Message index]

		Problem using a switch control By: Giorgio on Fri, 11 December 2015 09:04
		Re: Problem using a switch control By: mirek on Fri, 11 December 2015 13:03
		Re: Problem using a switch control By: Giorgio on Mon, 14 December 2015 15:08
		Re: Problem using a switch control By: mirek on Mon, 14 December 2015 20:49
		Re: Problem using a switch control By: Giorgio on Tue, 15 December 2015 10:31
		Re: Problem using a switch control By: mirek on Tue, 15 December 2015 12:46
		Re: Problem using a switch control By: Giorgio on Wed, 16 December 2015 15:10
		Re: Problem using a switch control By: mr_ped on Tue, 15 December 2015 22:19
		Re: Problem using a switch control By: Giorgio on Wed, 16 December 2015 15:03
		Re: Problem using a switch control By: mirek on Thu, 17 December 2015 10:11

Previous Topic:	Multiple lines on EditString
Next Topic:	Installation Problem in OpenSUSE Tumbleweed

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri May 01 06:22:01 GMT+2 2026

Total time taken to generate the page: 0.01261 seconds