Overview
Examples
Screenshots
Comparisons
Applications
Download
Documentation
Tutorials
Bazaar
Status & Roadmap
FAQ
Authors & License
Forums
Funding Ultimate++
Search on this site
Search in forums












SourceForge.net Logo
Home » Community » Newbie corner » Help setting up U++ on Debian 7
Help setting up U++ on Debian 7 [message #40553] Mon, 12 August 2013 14:19 Go to next message
lectus is currently offline  lectus
Messages: 329
Registered: September 2006
Location: Brazil
Senior Member
I followed the instructions at http://upp.invothink.com/nightly/README

U++ installs fine, but when I do

apt-get update


I get this warning
W: Duplicate sources.list entry http://upp.invothink.com/nightly/ wheezy/main amd64 Packages (/var/lib/apt/lists/upp.invothink.com_nightly_dists_wheezy_main_binary-amd64_Packages)


As I said it installs fine but I'm just reporting this to the repo maintainer.
Re: Help setting up U++ on Debian 7 [message #40554 is a reply to message #40553] Mon, 12 August 2013 16:42 Go to previous messageGo to next message
dolik.rce is currently offline  dolik.rce
Messages: 1758
Registered: August 2008
Location: Czech Republic
Senior Contributor

Hi Lectus,

I don't see anything wrong with the instructions on the first sight...

Could you check what is in your /etc/apt/sources.list.d/upp-nightly.list ? There should be only one line, containing something like
/etc/apt/sources.list.d/upp-nightly.list

deb http://upp.invothink.com/nightly wheezy main


Also, you can check if some of the other sources files (/etc/apt/source.list, /etc/apt/sources.list.d/*) doesn't point to the same address.

Best regards,
Honza
Re: Help setting up U++ on Debian 7 [message #40556 is a reply to message #40553] Mon, 12 August 2013 16:49 Go to previous message
lectus is currently offline  lectus
Messages: 329
Registered: September 2006
Location: Brazil
Senior Member
I think it was a problem with my sources list.

I now upgraded to Debian testing and it's running fine. U++ using wheezy though.
Previous Topic: Did something change in Controls4U? (Only drawing in Design mode)
Next Topic: Can't add asembly from bazzar
Goto Forum:
  


Current Time: Fri Dec 13 22:46:10 CET 2019

Total time taken to generate the page: 0.01115 seconds