Home » Developing U++ » U++ Developers corner » Install script for Ubuntu
Re: Install script for Ubuntu [message #37046 is a reply to message #37042] |
Sat, 11 August 2012 10:21 |
|
nixnixnix wrote on Fri, 10 August 2012 23:46 | Just installed theide by mistake and now have to delete virtual machine and start again. I am stupid I know but it would be good to have it in big letters somewhere that it should be
apt-get install upp
I guess putting a post-it on my monitor would do the job
|
No need to delete virtual machine or starting from start
If you accidentally did "apt-get install theide", running "apt-get install upp" will just add U++ sources to the already installed theide. If you already run theide and the settings wizard, you can just run it again (Setup->Source management..).
Alternatively, you can "apt-get remove theide" and then "apt-get install upp", the difference from above is just semantics.
Best regards,
Honza
|
|
|
Goto Forum:
Current Time: Thu Mar 28 10:24:04 CET 2024
Total time taken to generate the page: 0.01474 seconds
|