U++ framework: Newbie corner » Did something change in Controls4U? (Only drawing in Design mode)

Home » Community » Newbie corner » Did something change in Controls4U? (Only drawing in Design mode)

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Did something change in Controls4U? (Only drawing in Design mode) [message #40529]

Fri, 09 August 2013 18:32

lectus
Messages: 329
Registered: September 2006
Location: Brazil

Senior Member

I used to have a working application using Controls4U to draw a few rectangles to build an odontogram.

But now it's not drawing anymore when I run the app (only in the layout designer) (could be my mistake since it has been a few months since I last touched this project).

Any ideas?

Report message to a moderator

[Message index]

		Did something change in Controls4U? (Only drawing in Design mode) By: lectus on Fri, 09 August 2013 18:32
		Re: Did something change in Controls4U? (Only drawing in Design mode) By: lectus on Fri, 09 August 2013 18:55

Previous Topic:	Need help with algorythm
Next Topic:	Help setting up U++ on Debian 7

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri May 29 21:39:13 GMT+2 2026

Total time taken to generate the page: 0.00411 seconds