U++ framework: Newbie corner » Problem using a switch control

Home » Community » Newbie corner » Problem using a switch control

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Re: Problem using a switch control [message #45590 is a reply to message #45589]

Fri, 11 December 2015 13:03

mirek
Messages: 14291
Registered: November 2005

Ultimate Member

Testcase would be helpful, however, from what I see I bet that the problem is that all switch cases have the same value.

I think this would produce similar behaviour:

Switch sw;
...
sw.Add(0, "Case1");
sw.Add(0, "Case2");

[Updated on: Fri, 11 December 2015 13:03]

Report message to a moderator

[Message index]

		Problem using a switch control By: Giorgio on Fri, 11 December 2015 09:04
		Re: Problem using a switch control By: mirek on Fri, 11 December 2015 13:03
		Re: Problem using a switch control By: Giorgio on Mon, 14 December 2015 15:08
		Re: Problem using a switch control By: mirek on Mon, 14 December 2015 20:49
		Re: Problem using a switch control By: Giorgio on Tue, 15 December 2015 10:31
		Re: Problem using a switch control By: mirek on Tue, 15 December 2015 12:46
		Re: Problem using a switch control By: Giorgio on Wed, 16 December 2015 15:10
		Re: Problem using a switch control By: mr_ped on Tue, 15 December 2015 22:19
		Re: Problem using a switch control By: Giorgio on Wed, 16 December 2015 15:03
		Re: Problem using a switch control By: mirek on Thu, 17 December 2015 10:11

Previous Topic:	Multiple lines on EditString
Next Topic:	Installation Problem in OpenSUSE Tumbleweed

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Sep 06 04:57:26 GMT+2 2026

Total time taken to generate the page: 0.00714 seconds