Home » Community » Newbie corner » How to internet enable a serial device
Re: How to internet enable a serial device [message #32624 is a reply to message #32623] |
Sun, 29 May 2011 04:12 |
nlneilson
Messages: 644 Registered: January 2010 Location: U.S. California. Mojave &...
|
Contributor |
|
|
Hi Jerson
Yes it is a bit of a hump to get over the first time.
If you have more than one computer you probably have a router which is your link to the internet. If not they are about $40 U.S.
Then it's just the set up to your board, which I am not familiar with. With LAN cameras whatever board they use it's almost plug-n-play, there are a few settings but usually straight forward for as many cameras as you want.
Your board to router should take care of it.
If you don't mind keeping your computer on then your connection to the internet is through there even if you just have a phone modem.
[Updated on: Sun, 29 May 2011 04:29] Report message to a moderator
|
|
|
Goto Forum:
Current Time: Thu May 23 18:26:56 CEST 2024
Total time taken to generate the page: 0.01961 seconds
|