U++ forum: Welcome to the forum

Search on this site

Search in forums

Home » Community » Newbie corner » How do I 'check' a Switch control

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: How do I 'check' a Switch control [message #36217 is a reply to message #36216]

Sat, 12 May 2012 19:17

jerson
Messages: 202
Registered: June 2010
Location: Bombay, India

Experienced Member

You can check the selected case in the switch by reading its value to an integer.

Switch sw;
int swVal;

swVal = sw;

or select a particular case in code by doing this

swVal = 1; // select item 1 of the switch
sw = swVal;

Report message to a moderator

[Message index]

		How do I 'check' a Switch control By: awksed on Sat, 12 May 2012 17:35
		Re: How do I 'check' a Switch control By: jerson on Sat, 12 May 2012 19:17
		Re: How do I 'check' a Switch control By: awksed on Sat, 12 May 2012 20:14
		Re: How do I 'check' a Switch control By: Sender Ghost on Sat, 12 May 2012 21:18
		Re: How do I 'check' a Switch control By: awksed on Sun, 13 May 2012 17:51

Previous Topic:	time measurement :: RTIMING, TimeStop, GetTickCount
Next Topic:	Storing VectorMap

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Jul 18 10:01:10 CEST 2025

Total time taken to generate the page: 0.03851 seconds