U++ forum: Welcome to the forum

Search on this site

Search in forums

Home » Community » Newbie corner » HowTo bind StaticImage to SQL

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: HowTo bind StaticImage to SQL [message #43640 is a reply to message #43638]

Wed, 17 September 2014 12:32

jerson
Messages: 202
Registered: June 2010
Location: Bombay, India

Experienced Member

Hi Koldo

I realized that. Set has two overloads - Image and String.

Since StaticImage does not expose a SetData method, the SqlArray could not update the control when fed with a filename from the table.

Therefore, I created the SetData method and tied it down to Set(String& filename) and when SetData is fed with a string parameter, it works correctly now.

Regards
Jerson

Report message to a moderator

[Message index]

		HowTo bind StaticImage to SQL By: jerson on Sat, 13 September 2014 06:32
		Re: HowTo bind StaticImage to SQL By: Didier on Sat, 13 September 2014 22:26
		Re: HowTo bind StaticImage to SQL By: jerson on Sun, 14 September 2014 05:16
		Re: HowTo bind StaticImage to SQL By: jerson on Mon, 15 September 2014 07:58
		Re: HowTo bind StaticImage to SQL By: koldo on Tue, 16 September 2014 09:46
		Re: HowTo bind StaticImage to SQL By: jerson on Tue, 16 September 2014 10:25
		Re: HowTo bind StaticImage to SQL By: koldo on Wed, 17 September 2014 08:09
		Re: HowTo bind StaticImage to SQL By: jerson on Wed, 17 September 2014 12:32
		Re: HowTo bind StaticImage to SQL By: koldo on Thu, 18 September 2014 08:40

Previous Topic:	StaticImage cannot show BMP file
Next Topic:	>Port 9(say port 10)

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Aug 25 00:30:36 CEST 2025

Total time taken to generate the page: 0.04680 seconds