U++ forum: Welcome to the forum

Search on this site

Search in forums

Home » U++ Library support » U++ Library : Other (not classified elsewhere) » setting include-path

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: setting include-path [message #12552 is a reply to message #12493]

Thu, 08 November 2007 20:35

amando1957
Messages: 57
Registered: November 2007
Location: Wien/Vienna/Viden

Member

Hi,

Thanks for the hint. I have found the "be verbose", but i don't really understand: do i need to compile over the command-line, to get the info mentioned? I am not very fit with "cmd".

amando

Report message to a moderator

[Message index]

		setting include-path By: amando1957 on Mon, 05 November 2007 21:24
		Re: setting include-path By: mr_ped on Mon, 05 November 2007 21:58
		Re: setting include-path By: amando1957 on Thu, 08 November 2007 20:35
		Re: setting include-path By: mr_ped on Thu, 08 November 2007 21:32
		Re: setting include-path By: mr_ped on Thu, 08 November 2007 21:44
		Re: setting include-path By: amando1957 on Fri, 09 November 2007 12:29
		Re: setting include-path By: mr_ped on Fri, 09 November 2007 18:50
		Re: setting include-path By: mdelfede on Fri, 09 November 2007 19:55
		Re: setting include-path By: amando1957 on Sat, 10 November 2007 20:40

Previous Topic:	console + WIN-GDI
Next Topic:	ZCompress question

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Jun 07 12:23:37 CEST 2024

Total time taken to generate the page: 0.01734 seconds