Home » U++ TheIDE » U++ TheIDE: Compiling, Linking, Debugging of your packages » Strange build error only after changing
| Re: Strange build error only after changing [message #13822 is a reply to message #13812] |
Tue, 29 January 2008 12:56  |
mr_ped
Messages: 826
Registered: November 2005
Location: Czech Republic - Praha
|
Experienced Contributor |
|
|
You can't get "$blitz.obj" with BLITZ off (after clean UPPOUT).
So you must get different problem in such case.
Are you sure it's always the same problem?
If yes, use "verbose" ON and check out where is the $blitz.obj found and what paths are used when MSCC is called. But it is sort of "impossible", so watch out what is really going on.
I can't help with complex project structure (didn't had any "complex" enough, I think TheIDE is the most complex UPP project available with sources right now.)
|
|
|
|
Current Time: Fri Jul 18 09:58:19 CEST 2025
Total time taken to generate the page: 0.04762 seconds
|
Members
Pages
Help
Register
Login
Home
