U++ forum: Welcome to the forum

Re: Running a custom preprocessor on your sources [message #23526 is a reply to message #23525]

Tue, 27 October 2009 11:59

cbpporter
Messages: 1427
Registered: September 2007

Ultimate Contributor

I would like this to be done automatically because I am not editing only the files that are going to get preprocessed, and this must be done on every build. The result is also quite unreadable sometimes Smile

.

I have temporarily solved the problem. I created a project that contains the files that are going to be preprocessed. I created a rule in "Custom build steps" based on extension and gave the tool an output folder where I have created a second project. Then I open a second TheIDE instance on the second project. So it's build in first IDE, build and run in the second one.

Report message to a moderator