U++ forum: Welcome to the forum

Search on this site

Search in forums

Home » Community » Newbie corner » using a file chooser (dir chooser??) to get a dir and not a file

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: using a file chooser (dir chooser??) to get a dir and not a file [message #32755 is a reply to message #32753]

Mon, 06 June 2011 10:10

nlneilson
Messages: 644
Registered: January 2010
Location: U.S. California. Mojave &...

Contributor

Thanks again Honza

After doing a search in the upp directory for "SelectDirectory" and looking at the code in:
C:\upp\uppsrc\CtrlLib\FileSelUtil.cpp

A very basic use can be done with just this:

	void SelDir() {workdirField <<= SelectDirectory();}

Works great!

Report message to a moderator

[Message index]

		using a file chooser (dir chooser??) to get a dir and not a file By: nlneilson on Sun, 05 June 2011 11:41
		Re: using a file chooser (dir chooser??) to get a dir and not a file By: dolik.rce on Sun, 05 June 2011 18:34
		Re: using a file chooser (dir chooser??) to get a dir and not a file By: nlneilson on Mon, 06 June 2011 03:24
		Re: using a file chooser (dir chooser??) to get a dir and not a file By: dolik.rce on Mon, 06 June 2011 08:17
		Re: using a file chooser (dir chooser??) to get a dir and not a file By: nlneilson on Mon, 06 June 2011 08:42
		Re: using a file chooser (dir chooser??) to get a dir and not a file By: nlneilson on Mon, 06 June 2011 10:10

Previous Topic:	reading & writing a file
Next Topic:	Restricting GridCtrl Selection to just One row

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Aug 24 13:27:47 CEST 2025

Total time taken to generate the page: 0.04800 seconds