U++ forum: Welcome to the forum

Search on this site

Search in forums

Home » Developing U++ » UppHub » OpenCL

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: OpenCL [message #38158 is a reply to message #37963]

Mon, 03 December 2012 06:43

Novo
Messages: 1430
Registered: December 2006

Ultimate Contributor

Status update:

I'm still far away from finishing the wrapper. It will probably take me another week to do that.

What is the best place to put initial version? Bazaar of sandbox?

Regards,
Novo

Report message to a moderator

[Message index]

		OpenCL By: Novo on Sat, 23 July 2011 06:32
		Re: OpenCL By: Didier on Sat, 23 July 2011 12:53
		Re: OpenCL By: 281264 on Sat, 23 July 2011 18:13
		Re: OpenCL By: Novo on Sat, 23 July 2011 18:42
		Re: OpenCL By: 281264 on Sat, 23 July 2011 18:49
		Re: OpenCL By: Novo on Mon, 25 July 2011 05:05
		Re: OpenCL By: 281264 on Mon, 25 July 2011 10:36
		Re: OpenCL By: koldo on Thu, 22 November 2012 06:46
		Re: OpenCL By: Novo on Sat, 24 November 2012 02:30
		Re: OpenCL By: koldo on Sun, 25 November 2012 09:33
		Re: OpenCL By: Novo on Mon, 03 December 2012 06:43
		Re: OpenCL By: koldo on Mon, 03 December 2012 08:23
		Re: OpenCL By: 281264 on Wed, 05 December 2012 22:38
		Re: OpenCL By: Novo on Wed, 12 December 2012 06:00
		Re: OpenCL By: koldo on Wed, 12 December 2012 08:25
		Re: OpenCL By: 281264 on Fri, 14 December 2012 20:49
		Re: OpenCL By: Novo on Fri, 14 December 2012 22:12
		Re: OpenCL By: 281264 on Fri, 14 December 2012 23:04
		Re: OpenCL By: Novo on Sat, 15 December 2012 01:27
		Re: OpenCL By: 281264 on Sat, 15 December 2012 11:37

Previous Topic:	Added OCE (OpenCascade Community Edition) 3d solid modeling kernel -- UPDATED to 0.10 version
Next Topic:	OfficeAutomation - Update Requests

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Apr 26 18:33:29 CEST 2025

Total time taken to generate the page: 0.03011 seconds