U++ forum: Welcome to the forum

Search on this site

Search in forums

Home » Community » Newbie corner » Can't Ultimate++ use Japanese?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Can't Ultimate++ use Japanese? [message #46133 is a reply to message #46092]

Tue, 15 March 2016 23:39

kurete
Messages: 17
Registered: March 2016
Location: Japan

Promising Member

I'm sorry to be late.

I changed the compiler to MinGW from MSVC 2015 and then that went well.

Also, I was able to use the source code of Mr.deep.

However, I don't know that TheIDE stop movement when the encode is changed and I input Japanese in this state.

Perhaps the cause is my environment. I use Japanese Windows7 32bit.

Report message to a moderator

[Message index]

		Can't Ultimate++ use Japanese? By: kurete on Thu, 03 March 2016 21:01
		Re: Can't Ultimate++ use Japanese? By: koldo on Fri, 04 March 2016 09:11
		Re: Can't Ultimate++ use Japanese? By: mr_ped on Sat, 05 March 2016 00:55
		Re: Can't Ultimate++ use Japanese? By: kurete on Tue, 08 March 2016 10:59
		Re: Can't Ultimate++ use Japanese? By: deep on Mon, 14 March 2016 13:03
		Re: Can't Ultimate++ use Japanese? By: deep on Mon, 14 March 2016 13:12
		Re: Can't Ultimate++ use Japanese? By: kurete on Tue, 15 March 2016 23:39
		Re: Can't Ultimate++ use Japanese? By: mr_ped on Wed, 16 March 2016 10:58

Previous Topic:	"\n" does not work on DrawText
Next Topic:	Ridiculous behavior of the hotkeys Ctrl+Alt+right and Ctrl+Alt+left in the Stacking mode

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat May 03 05:25:35 CEST 2025

Total time taken to generate the page: 0.04557 seconds