U++ forum: Welcome to the forum

Commandline builds (linux) [message #22453]

Fri, 17 July 2009 00:35

dolik.rce
Messages: 1789
Registered: August 2008
Location: Czech Republic

Ultimate Contributor

Hi,
Today I wanted to build a package on a remote linux machine, using TheIde from a command line. From what I found in manual and in this thread, TheIde should compile the specified package without invoking GUI.
But it's not completly accurate. TheIde doesn't show up at all, as expected, but windows about updating codebase and Assist++ still appear on start.
I was trying this over ssh and it works only if X forwarding is permitted. If it's not then following error appears:

No protocol specified
No X11 display, errno = 0, Succes
X11 error !

I also tried in console on my local machine and got an "couldn't open display" error.

Appart from this, everything works perfectly. It's just a bit annoying, because I was on a very slow connection and the forwarding of those two dialog boxes took longer than the rest of compilation...

Report message to a moderator