U++ forum: Welcome to the forum

Problem Building Sample Applications [message #13786]

Sat, 26 January 2008 22:23

hcetupli
Messages: 1
Registered: January 2008

Junior Member

Hi,
I have just downloaded Ultimate++ and tried to build one of the samples (HelloWorld) as a test.

I had no success instead recieved loads of errors (>100). A couple of which are below:

C:\WATCOM\H\NT\objidl.h(1074) : error C2061: syntax error : identifier 'PRPC_MESSAGE'
C:\WATCOM\H\NT\objidl.h(1076) : error C2061: syntax error : identifier 'PRPC_MESSAGE'
C:\WATCOM\H\NT\objidl.h(1076) : fatal error C1003: error count exceeds 100; stopping compilation

There seems to be references to the path C:\WATCOM\ which is used by OpenWatcom which I also have installed.

This doesn't cause a problem for MinGW when installed on its owm.

I downloaded Ultimate++ with MinGW and configured it to use its onw version of MinGW.

Therefore why is it producing errors and apparently referencing OpenWatcom?

I can't find any settings to stop this???

Thanks.

Report message to a moderator