Home » U++ Library support » U++ Library : Other (not classified elsewhere) » navigate does not always work correctly
Re: navigate does not always work correctly [message #28638 is a reply to message #28637] |
Wed, 08 September 2010 19:32 |
|
Hi aftershock,
What exactly do yo mean by navigate? Assist > Navigate ... (Ctrl+J)? If so, then it works fine, at least for me. It shows the matching names, sorted alphabetically and in case of multiple same names also by scope. As far as I can tell it always dropped me to the right place.
If you mean the navigator panel (Ctrl+N), then it should allow you to see all declarations and definitions by clicking it multiple times. If it got you to different scope, then there might be something wrong with it.
Was it some specific term/place in code? It would be great to know where to look...
Honza
|
|
|
Goto Forum:
Current Time: Sun May 05 00:32:09 CEST 2024
Total time taken to generate the page: 0.02016 seconds
|