Home » Community » Newbie corner » Filtering CR from an EditString
Re: Filtering CR from an EditString [message #45126 is a reply to message #45120] |
Tue, 08 September 2015 11:29 |
|
deep
Messages: 263 Registered: July 2011 Location: Bangalore
|
Experienced Member |
|
|
Hi Giorgio,
I think changing setup of bar code scanner may be right solution.
Check setup. It will be possible to stop additional characters sent by scanner in scanner setup.
There is normally provision in scanner setup to add Prefix and Suffix chars.
Most likely double "CR" is added as suffix.
Warm Regards
Deepak
[Updated on: Tue, 08 September 2015 11:29] Report message to a moderator
|
|
|
Goto Forum:
Current Time: Wed May 08 07:46:25 CEST 2024
Total time taken to generate the page: 0.02211 seconds
|